| 1. | Vhc vacuum exhaust heat control valve
真空排气热控制阀 |
| 2. | Ehc exhaust heat control
排气热量控制 |
| 3. | Optimization design and experiment on exhaust heat exchanger of gas engine - driven heat pump
天然气热泵排烟换热器优化及实验 |
| 4. | Exhaust heat loss
排气热损失 |
| 5. | The performance and basic parameters of several adsorbent beds driven by different diesel exhaust heat are experimentally obtained
吸附工质对采用氯化钙一氨。对不同吸附床在不同热源条件下的基本性能参数进行了测试。 |
| 6. | The intermediate pressure exhaust gas boiler in the shop of yantzi petrochemical oil refinery works is needed to recycle the exhaust heat from the dust
扬子石化炼油厂催化裂化车间中压余热锅炉，用来回收催化再生烟气的余热。 |
| 7. | In order to simulate parameters of different diesel exhaust heat , an simulative multi - heat testing flat is set up with an combustor and two fans
采用燃烧器和两个离心风机构成的二级送风系统组成模拟多热源实验台，以模拟不同的内燃机余热条件。 |
| 8. | The working pairs and cycles suitable for diesel exhaust heat recovery are chosen . the empirical adsorption rate of cacia ? ha pair is modified through experimental investigation for non - equilibrium adsorption condition . 2
确定了适合内燃机余热回收的吸附工质对和循环方式，在非平衡吸附的条件下，采用实验测试手段，修正了氯化钙一氨工质对的经验型吸附速度方程。 |
| 9. | On base of the exhaust heat of 6160a - 12 and 6160a - 13 vessel diesel engine , parameters of test plat such as thermal flow , export temperature and pressure are definite through the calculation of design parameter in method of combined theory and experience data
以6160a - 12和6160a - 13型船用柴油机尾气参数为设计基础，通过理论和经验数据相结合的方法进行设计参数计算，确定了模拟实验台热流量、出口温度及压力等参数。 |
| 10. | Based on the exhaust heat data of the iurbine ( 6160a - 12 ) and the micro gas turbine produced in japan , parameters of test - bed such as deferent thermal flow temperature and pressure are defined by the calculation of design parameter in method of combined theory and experience data
以柴油机( 6160a - 12 )和日本的微型燃气涡轮机尾气参数为设计基础，通过理论和经验数据相结合的方法进行设计参数计算，确定了模拟实验台热流量、出口温度及压力等参数。 |
